Link-systems LinkNet I Manuel d'utilisateur télécharger pdf (Page 47)

LinkNet

A.7

manual rev 2.1 March 25, 1999

A.3.7 OmniLink Auto-Setup Module Software

Upgrade Procedure

This upgrade procedure applies only if the

OmniLink control has an extended card rack and has

the auto-setup module installed.

Review the chip changing rules of section A.1.

Remove power from the OmniLink card rack

and

the OIT.

Remove the Auto-Setup board from the card

rack.

Remove the module (if present) installed in the

SS1 position.

Using Figure A.11, locate and remove the 5000-

10 chip.

Figure A.11:

OmniLink 5000 Auto-Setup

Module Circuit Board.

Insert the new 5000-10 chip.

If a module was removed from SS1, replace it.

Insert the Auto-Setup Module in the card rack.

1 2 ... 42 43 44 45 46 47

Pas de commentaire

Link-systems LinkNet I Manuel d'utilisateur Page 47