Link-systems Omni II Automatic Setups Module Manuel d'utilisateur télécharger pdf (Page 61)

October 16, 2008 Manual Version 1.1

6-7

Coarse/Inc Turn Count Out of Synch

The incremental turn count does not match the coarse

resolver turn count. This could be caused by a bad connection or a

hardware problem on the rotary circuit board (5100-10C).

Rotary Transducer Read Failure

The value read from the rotary transducer is invalid. This could

be caused by a bad connection, a bad rotary transducer, or a hardware

problem on the rotary circuit board (5100-10C).

Rotary Max Speed Exceeded

The maximum number of revolutions per second has been

exceeded. It may be necessary to gear down the input shaft of the

rotary transducer

Unknown Transducer Type

The automatic circuit board detection system has detected an

unexpected type of circuit board. The firmware on the main board

(5100-10) will need to be updated.

1 2 ... 56 57 58 59 60 61 62 63 64 65 66 ... 76 77

Pas de commentaire

Link-systems Omni II Automatic Setups Module Manuel d'utilisateur Page 61