Link-systems OmniLink 5000 Manuel d'utilisateur télécharger pdf (Page 15)

3.4

19 PLC Screen 1 Sets Change parameters on Screen 1 of the Programmable

Logic Controller Interface

20 PLC Screen 2 Sets Change parameters on Screen 2 of the Programmable

Logic Controller Interface

21 PLC Screen 3 Sets Change parameters on Screen 3 of the Programmable

Logic Controller Interface

22 PLC Screen 4 Sets Change parameters on Screen 4 of the Programmable

Logic Controller Interface

23 Special Interface Change parameters on the Special Interface Screen

24 Auto SS/COD Time Change the Automatic Single Stroke maximum time

between strokes, the Continuous on Demand maximum

time between Run cycles, and the Feed Complete Angle

25 Reset Brake Monitor Reset Brake Monitor faults

26 Motor Speed Adjust Adjust motor speed

27 Store Jobs Store jobs in memory, edit Machine Notes and Job

Notes

28 Recall Jobs Recall jobs from memory

29 Erase Jobs Erase jobs in memory

30 Reserved for future use

31 Reserved for future use

32 Reserved for future use

Section 3.3 Access Control Operation

To gain access control the user must use one of two means or a combination of these two means. These

means are the Program/Run key or the user password system.

Section 3.3.1 Program/Run Key Switch Operation

The Program/Run key switch is located on the lower right side of the operator terminal. This is a two

position switch. The key is removable in the RUN position only. If the Program/Run key switch is being

used as a means to access the restricted items, the switch must be turned to the PROG position. When the

Program/Run key switch is switched to the PROG position, the press will Top Stop and stroking will be

prohibited until the switch is returned to the RUN position.

When operating in the Key Only mode the key switch is the only means available to access the restricted

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 114 115

Pas de commentaire

Link-systems OmniLink 5000 Manuel d'utilisateur Page 15