Link-systems OmniLink 5000 Manuel d'utilisateur télécharger pdf (Page 50)

5.3

Stroke

Mode

Sin

le Stroke

Drive

Speed

Stroke

Speed

SPM

200

Order

Counter

PC STATUS

Counter OFF

TOP STOP

CALIBRATE

CHANGE

NUMBER

Program/Run Switch

TOP

EXIT

MOTOR

SPEED

Speed Advance Top Stop

Stroking

Mode

Single

Continuous

Speed and Stopping Angle

340

338

100

330

328

150

320

318

200

310

308

RPM

[ Calculated }

Speed Top Ang

Measured

Stop Ang

Ch A 050 340 340

Ch B 050 340 340

Stop Pos (Setup Mode) = 090

2 3 4

Figure 5.3 Top Stop Configuration Menu Link

Standard Firmware

The display shows the following information:

1. The programmed lowest operating speed of the machine.

2. The programmed speed approximately 1/3 of the way between lowest and highest programmed

speeds.

3. The programmed speed approximately 2/3 of the way between lowest and highest programmed

speeds.

4. The programmed highest operating speed of the machine

5. The programmed angle at which the press will begin to stop when running at each speed shown.

These four angles are used when the press is in a single stroke mode, and will automatically stop at

the end of each stroke.

6. The programmed angle at which the press will begin to stop when running at each speed shown.

These four angles are used when the press is in continuous running mode.

7. The actual speed of the crankshaft and computed top stop position recorded by the press control each

time a stroke is made.

8. The programmed angle at which the press will begin to stop in the downstroke when operated in

Setup/Stop Time Test mode. See Section 5.1.3.

1 2 ... 45 46 47 48 49 50 51 52 53 54 55 ... 114 115

Commentaires sur ces manuels

Pas de commentaire

Link-systems OmniLink 5000 Manuel d'utilisateur Page 50

Commentaires sur ces manuels

Produits connexes et manuels pour Instruments de mesure Link-systems OmniLink 5000